question

davidp avatar image
davidp asked

Micro-inverters compatible with MP2 ?

Hi. I read many posts about micro-inverter but can we find somewhere wich ones are compatible with frequency shifting ? (connected to AC out 1).

- Enphase IQ7: seem OK (but expensive because Q relay/console),

- Hoymiles: seem OK,

- APSystems: NO

Thank you for your feedback.

David.

Multiplus-IImultiple invertersfeed-in limitenphase
1 comment
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

nuxland avatar image nuxland commented ·
I have 14pcs of APSystems YC1000 microinvertes that are connected to AC-OUT.

And I have configured each of the YC1000 to be 0,1Hz higher shutdown then previous.

So when battery is full (and not connected to grid) and multi will start to increase frequency then production will also start to decrease because micros will start to shutdown one by one.


But You are right, Out of the Box APSystem is not compatible with Victron (It is not communicating with it)

0 Likes 0 ·
1 Answer
Matthias Lickert avatar image
Matthias Lickert answered ·
I Have for bad weather days one APSystems QS1 (1600kWP) on Power phase 1 AC Out 1 MP-II Nr.1 that bring Power but second one, the Growatt MIN 3600TL-XE (with 900kWP) Power phase 2 AC Out 1 MP-II Nr.2 brings just 9W Power. The Voltage is changeing from 225V to 232V. the smallest and largest settings are far below and above. So you probably can't set anything. when the weather is good, I can switch off these two inverters via AVM Dect sockets
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Related Resources