Hello, I am about to install a split phase system with 3 x Quattro II 24v.
Manual says no mk3-usb needed for Multiplus II.
Is this also valid for Quattro II ?
Best Regards
Thees
This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Hello, I am about to install a split phase system with 3 x Quattro II 24v.
Manual says no mk3-usb needed for Multiplus II.
Is this also valid for Quattro II ?
Best Regards
Thees
What manual would this be?
VE bus devices need a mk3 for proper setup.
From the manual:
Same applies to MP2.
Hi, thanks, yes, understood, I was wrong.
I ment the following:
Note: AC Detector for MultiPlus and Quattro (included in VE.Bus BMS delivery) not needed for MultiPlus-II models
Does this also apply to the Quattro II?
Best regards, thees
58 People are following this question.