Hi all – noticed a change in my Easysolar behaviour this morning.
EasySolar 3KVA
Using AES – modified sine wave for over a year now.
This morning, appears the inverter is using full power when in Low Power. From memory it used to consume as per the spec sheet around 12w in this mode, but in this photo it’s using around 32w. (understand these numbers may not be ultra precise but used a clamp meter and saw 0.6xx amp being drawn from the battery which is near enough.)
My battery voltage was lower than normal this morning which is what brought this to my attention. In fact it looks like the led’s for the charger on the front panel are very faintly flashing.
After seeing this, went and set the AES to ‘search mode’ and that worked (ie searched every couple of seconds) then reset AES back to ‘modified sine wave’. I also reloaded a saved config from January but that didn’t make any difference either as still drawing full power.
Any ideas what may be the cause? Thanks.