Hello all,
I have just tried to set up 3 24/1600 Phoenix inverters in parallel
I have connected the DC and i have installed the Cat 5 cables looping them together. I tried to test them before i actually set them up through VE BUS Quick config. I just turned them on individually with no AC cable connected. Just to see if i could connect to them with VE config. But i have 2 Inverters that have a solid red alarm. No matter if i switch to on or eco mode. 1 works fine and will run. I have also disconnected the Cat 6 cables and they are still solid red. Is there a way to reset the inverters or are they stuffed. They are brand new.