question

bootfahrer0815 avatar image
bootfahrer0815 asked

virtual switch (vs): Is it possible to switch it manually?

I use the VS to ignore the AC-input (shorepower) or not. If I´m on holiday and see, that the SOC of my batteries is too low, it would be fine, if I could activate the VS remotely, so that the shorepower can load my batteries. I don´t want to wait sometimes, that the system will switch the VS depending on my configured conditions for switching.


Thanks for help!

Greetings!

Rainer

VEConfigure 3shorepowervirtual switch
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

1 Answer
Alexandra avatar image
Alexandra answered ·

@Bootfahrer0815

If you have programmed using the virtual switch tab, I have not seen a solution.

you can use assistants however like the ignore AC with generator assistant or the ignore ac assistant and use the GX relay to override the conditions.

There are a few posts with adaptations of its uses.

https://community.victronenergy.com/questions/85215/can-gx-generator-startstop-feature-control-ac-in-o.html

https://community.victronenergy.com/questions/52652/multiplus-mains-led-flashing-1.html

there are quite a few other ideas, it takes a bit of fiddling to get right.

2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Related Resources

Additional resources still need to be added for this topic

Additional resources still need to be added for this topic

VE Configure/Virtual Switch

Ignore AC input using the Generator Assistant

VEConfigure manual

VEConfig alternative method for VE.Bus using VictronConnect