This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
I have installed BMV 712 with a 420 Ah house battery bank and a 55Ah starter/Aux battery. Everything appears okay except one read-out which I do not understand: looking at the display modes, when I come to the "Time-to-go" display I get the mid-point characters (as shown on p.5 of the manual, under 1.2 b), instead of getting any kind of number as shown on p. 8. What am I missing or not understanding?
Can you sent a photo of this?
Can you check which firmware is in the unit?
best regards
Martijn Coster
Paging through the manual on p.8, it says that the results for "Time-to-go" would be the estimated remaining hours to reach the discharge floor. But look what it shows. This was done will the battery bank was in float at 100% charge.
This stands for INFINITE.
When this appears on BMV, there is more power going into the battery than out. So The Time To Go is infinite.
