question

merav avatar image
merav asked

Easysolar not diconnecting my system when the batteris are low.

My solar system is EasySolar24/1600 and BMV-700.
However, last week the batteries went down to %0 (because the solar panels got disconnected by accident for 2 days).
My understanding was that the Easy Solar need to disconnect the system at factory setting to protect the batteries from ever going down to %0.
Any thoughts on what is wrong here ?
Thank you very much

merav

EasySolar All-in-One
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

2 Answers
klim8skeptic avatar image
klim8skeptic answered ·

What values have you programmed the Multiplus regarding low battery shutdown?

multi-low-batt-shutdown.png

Note, the Soc in the above shot refers to the multiplus's calculated Soc, not the BMV readings.


multi-low-batt-shutdown.png (129.5 KiB)
1 comment
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

kevgermany avatar image kevgermany ♦♦ commented ·

@merav also the easysolar cannot control DC loads

0 Likes 0 ·
merav avatar image
merav answered ·

The unit was programed by a friend, who is not available to contact now.

1 comment
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

kevgermany avatar image kevgermany ♦♦ commented ·
Unless you can find someone else to help, you must monitor manually. But also look at loads connected direct to the battery.
0 Likes 0 ·