I have an IP67 12/25 that I've been using regularly to charge my SOK 12volt/206ah battery. This past weekend when I hooked it up (I have an anderson connector on both the charger and battery and disconnect the battery from my power panel when charging) to charge the Victron Connect app was showing that the charger went immediately into absorption mode at 14.4 volts and 0.0 amps.
Given the reputation anid quality of the Victron products, and the fact that there's virtually no serviceable parts of the IP67 I thought there must be something wrong with the battery. After speaking with SOK about the problem, and doing some troubleshooting steps they agreed and sent me a replacement BMS, I got the BMS today and installed it and the charger is still showing 14.4v/0.0 amps.
Is there some kind of troubleshooting I can do with the IP67 to see if there's something wrong with the charger, or the settings?
Also note, I tried all of the different modes on the IP67, including putting it in power supply mode at various voltage settings. I'm at a loss for other things to try with this so any help or advice will be greatly appreciated.