I have a 2,8kW max (10A) "non inverter/AVR" generator connected to Easy Solar II 24/3000. This generator can power directly 2,5kW Bosch AXT 25 TC branch shredder for hours.
Battery is first charged 100% by generator, which charges 35A with Weak AC option ON, and 50A without it (which is max for my battery, also my battery has 200A constant discharge rate).
Also i have 1,2kW of solar panels in good sunlight, but sadly as soon as generator is connected, SmartSolar stops supplying current to the system (solar input stays at 70V but current goes to 0A).
I start 800W heat gun, generator tries to ramp up rpms but inverter almost immediately disconects the generator.
I have tried lowering AC1 input current limit minimum - 3,5A (and also maxed all the way to 10A). Doesnt work still.
Settings:
UPS OFF (also tried ON),
AC1 input current limit - 8A
Dynamic current limit ON (also tried OFF),
Accept wide frequency range ON,
AC low voltage disconnect 180V (and also tried 210V as suggested in the manual),
Power Assist on, assist factor 2 (also tried 1 and 1.5)
Nothing works.
Is the generator just too slow/low quality or are there any other settings i can try to keep generator connected until it revs to suitable speed/voltage?