I'm using ESS assistant configured using VEConfig on Phoenix Multi Compact 24/800/16-16 and 25.6V (2x12.8V, 160 Ah, Victron Energy LiFePo4 Smart) battery storage with VE.Bus BMS. When discharging the battery, ESS shuts off the system and transfers battery into "sustain" mode around 20-30% SOC (using BMV 702 battery monitor), depending on the load. I understand that dynamic cut-off controls the maximum discharge level of the battery, but I would like to use additional (rated or near-rated) capacity of the battery. I'm currently using default settings for dynamic cut-off voltages in ESS assistant that are already preconfigured when installing ESS assistant.
My question is, what should I set in ESS assistant for dynamic cut-off voltages to reach 0% (or lower than 20%) SOC in operation? What are the minimum voltage settings that I should use? I cannot find any minimum/recommended values in documentation.