question

If you are using a Cerbo GX that is connected to the internet you can graph the output of your wind generators in the VRM app. To do this you need to have a SmartShunt configured as a DC Energy Meter. I don’t have a wind generator - The graph is comparing solar output from 2 MPPTs with the output from my alternator.

I am not sure I follow what the issue is. I have a smart shunt, connected to the negative of my wind generator. The smart shunt is configured as a DC Monitor with the monitor type of Wind, as shown in the VictronConnect app.

This is then visible on the CerboGX running VenusOS

And in VRM advanced tab I can get the historical reporting.

As long as the Smart Shunt is connected via a VE.Direct cable into the VenusGX then all the above works.

It is not displayed on any of the Graphic overviews on the Cerbo GX (VenusOS) or VRM, but there are so many devices and permutations of DC sources and loads that displaying them all in Graphical format is a challenge.

Thanks, Sarah and Bathnm for your replies,

maybe I did not use the right words/notations: I succeeded in reading the power of my windgenny via the DC-Shunt and in the device list. But I hoped to find it like my mppt trackers in the DASHBOARD to have an overview, which power comes from where and goes to where.

And I also was disappointed not to find the ET112 AC meter that I installed to read out the power I burn in my water tanks when the batteries are full. Also here I can read the actual active power and the sum since installation, but the device is not shown in the dashboard, where it would be fine to see at a glance where the AC power is used....

Does anybody know if this is generally possible?

Thanks,

Martin