good afternoon, i am in the beginning stages of converting my TT from LA to LIFePo4. I have purchased a CHINS 12.8v 300ah lifepo4 battery and i have already upgraded my LA WFCO charger to the proper WFCO charger to handle LI battery charging.
I have pulled the 6ga pos & neg battery cables to the inside compartment under master bed where my battery system will reside.
Here are my questions:
1) are the 6ga wires big enough for this new system?
2)i plan on ordering the Victron Energy SmartShunt 500 amp Battery Monitor
3) i am told i need an auto switch, to go back and forth from shore power to battery power, is there a Victron model?
4) i also need an inverter to use my 110V side of my trailer when not plugged in to shore power (i'm aiming for a 2000W pure sine inverter)
5) ordered battery cutoff switch
6) my main questions are:
a)since the TT already uses 6ga wire, can i stay w/ 6 ga wire to connect the shunt, switch & inverter?
b) am i missing anything? do i need bus bars, inline wired fuses (what amp fuse), larger fuses?
c) install directions to wire all this up? My local RV dealers are clueless so this is DIY
TIA for any help!