question

offroadflow avatar image
offroadflow asked

How to figure out which inverter is for what phase (three phase)

Hello,

How can i figure out what inverter is what phase in a three phase system (3x 48/5000/70?

I have full remote access.

Thanks!

3 phase
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

2 Answers
Mike Dorsett avatar image
Mike Dorsett answered ·

Use VE configure to blink the led's on each inverter in turn, this will identify them. However, this is normally a local procedure, I don't know if it can be done remotely.

2 comments
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

offroadflow avatar image offroadflow commented ·
In this case I'd have to shut down the whole system in order to do so, right?


0 Likes 0 ·
offroadflow avatar image offroadflow offroadflow commented ·
@Mike Dorsett ?


0 Likes 0 ·
Mike Dorsett avatar image
Mike Dorsett answered ·

No, a shut down is not necessary to do this.

you will need a Mk2 /3 interface and the software, then you can flash the leds on a particular inverter to identify it.

2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.