question

rvan-gils avatar image
rvan-gils asked

Easysolar II GX Display status-off problem

Updated the firmware today. But now my display status is off. Normally is states HUB-1 on and xxx watt.

BMV-700 firmware v3.08

Multiplus II Firmware 490

Smartsolar MTTP 250/70 firmware v1.59

Everthing works fine, remote desktop, load, etc. Exept the dispay.

I tried a lot. Reset, completely powerless and at last firmware update again with default settings. No result.


Anybody an idea?

With kind regards,

Ramon

EasySolar All-in-One
1 comment
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

rvan-gils avatar image rvan-gils commented ·
It is working again. It's the firmware. I replaced it with the older firmware.
0 Likes 0 ·
2 Answers
marekp avatar image
marekp answered ·

@Rvan Gils

Did that display work at any time?

There is a ribbon cable between display and GX board.

See if it is connected properly.

2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

rvan-gils avatar image
rvan-gils answered ·

The display itself is working fine, as is the button to select different information. So it displays the solar status and the power usage. But no more hub status.

2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.