This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Hi,
I was wondering if anyone has a similar setup that has the battery settings (obviously I know the capacity) for the Shunt that is working for them?
The charge parameters from Sterling are;
The Shunt rarely (if ever) shows the correct SoC once the battery begins to discharge and there is a rabbit hole of information on the WWW.
Any advice and pointers greatly appreciated.
Thanks
Confirm:
Capacity is set correctly
Peukert is set to 1.05
Charged voltage is 0.2V below absorption (solar charging) or float (AC charging)
Tail current is 5%
If using aux input Temp, make sure temperature coefficient is 0
If none of the above resolve it, remove all devices from load side of shunt and conduct zero current calibration.
