question

nonemauro avatar image
nonemauro asked

MPPT Ground to chassis or common bus bar

This question is regarding the Victron 100/50 MPPT Smart Solar Charger for a van conversion installation.

The entire electrical system is grounded to the van chassis. Specifically, I have a wire bolted to the van and then connected to the main negative bus bar.

I have the negative wire of the MPPT Smart Solar Charger connected to the main negative bus bar, and the positive wire of the MPPT Smart Solar Charger connected to the main positive bus bar.

Can the ground wire of the MPPT Smart Solar Charger also be connected to the negative bus bar or should it be connected to the van chassis?

I would prefer that the ground wire not be connected to the van chassis, but rather connected to the negative bus bar, along with all the other negative wires.

Hoping to get some more clarification on this.

thanks


MPPT SmartSolarwiringGrounding
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

1 Answer
richard70 avatar image
richard70 answered ·

see https://community.victronenergy.com/questions/100185/smartsolar-mppt-chassis-grounding-confusion-for-ca.html

2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Related Resources

MPPT product page

VictronConnect manual

PWM or MPPT

MPPT calculator

MPPT codes

Ground, earth and electrical safety


Additional resources still need to be added for this topic

Additional resources still need to be added for this topic