Hello,
I have a Lynx Shunt VE.Can that will not show up on my Cerbo GX as a VE.Can device. Other VE.Can devices will show up, but I have disconnected them for troubleshooting the shunt. I have a Cat6 UTP RJ45 cable connected directly between the VE.Can ports on the shunt and the Cerbo, with a blue terminator plug on both ends. The shunt's LED is green and current is flowing. RJ11 cables are connected to Lynx Distributers left (batteries) and right (loads) of the shunt. The VE.Can port status page from the Cerbo interface is attached.
Please let me know any suggestions or additional info needed.
Thank you!