This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
On my iPhone my app finds the Smart BMV with good signal strength. Once I tap the only device I have it goes to " connecting " and runs through the % to 100. Then on to fetching data. It tries " fetching data " for about thirty seconds then loops back to " connect "
this becomes an endless loop
Hi @Sam Houston
Can you perhaps post a service report in a comment (or answer) after going though the fetching data loop once? The procedure to make a service report is described here: https://ve3.nl/VictronConnect_How-to-create-a-VictronConnect-Service-Report
Kind regards,
Thiemo van Engelen
@Sam Houston I commensurate with Apple continuous loop frustrations. If I choose to monitor anything on my device list, I first power down the iPhone, wait a few seconds then power up the iPhone, then go to the VE app, then choose the device. You may need to re-install your device on the iPhone app.
