Hello, i have an installation in which an ET112 measures the shore power. The 230V for the AES refrigerator and the AC input from the MultiPlus are taken in parallel behind it.
It is strange that the load of the refrigerator is displayed in the AC-Out tile of the MultisPlus.
So more precisely. For example when
- ET 112: 222 W.
- Fridge: 189W
- AC-In: 33W
- AC-Out: 16W
Then that would be mathematically correct. However, the following is displayed:
- ET 112: 222 W.
- Fridge: 189W
- AC-In: 207W
- AC-Out: 178W
I hope the pictures say more than my explanation
- vic1.jpg -> fridge off
- vic2.jpg -> fridge on
- vic3.jpg -> detailed view of the MultiPlus at the refrigerator
normally AC-OUT L1 should actually be displayed in the green tile (AC Loads).
Which settings would be correct here?
Thanks very much!
(PS. excuse my bad English.)