I changed my charge settings on my 16a charge / shoreline connection, for my new lithium system, everything was fine, and the charger out in a about 60amp charge alongside orion ant about 30amps and a few amps of sola.
all was good, batteries very happy at about 98% soc. charge sources disconnect to avoid possibility of over charge, all fine, later when turned on inverter, but wouldn’t activate. Breaker on output appears blown or at least wont switch back on.
I might add, the system is composed of 2x 200ah victron smart lithium battery, in parallel in to a lynx distributor, lynx bms, and another distributor (which easy solar is connected to, as is a 30mp orion, and a battery protect for 12dv loads)
It was fairly hot when charging, but not dangerously so and there were no warnings from colour control or bms in app. (All notifications turned on)
Changed main fuse inside easy sola, no change.
perhaps need to replace breaker? But concerned it will happen again.
Please help!