question

ruffian avatar image
ruffian asked

BMV-700 Monitor Settings with BAT412101104

All,

Please can you help me figure out what the correct values for the;


    • Charged Voltage
    • Tail Current
    • Charge detection time
    • Peukert exponent
    • Charge Efficiency

should be on my BMV 700.

The BMV is monitoring 3 victron Gel BAT412101104 in the setup outlined below.

schematic.jpg

schematic.JPG

Any help would be very much appreciated.

Thanks

Iain

BMV Battery MonitorCyrix Battery Combiner
schematic.jpg (83.8 KiB)
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

2 Answers
klim8skeptic avatar image
klim8skeptic answered ·
1 comment
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

ruffian avatar image ruffian commented ·
Many thanks for the video. I've watched the video before but was hoping that as everything in the system is victron, then someone from Victron, or their distribution network would be able to confirm exactly what the settings should be.


The video's talk about 'slightly below' and 'should be fine', but I'd like Victrons veiw on the correct settings within this victron configuration.

Regards

Iain


0 Likes 0 ·
pwfarnell avatar image
pwfarnell answered ·

To start with the help here is from a community of Victron users not Victron.

The first thing to know is what charge settings you have on the MPPT controller, especially the absorption voltage. Then the charged voltage and tail current settings can be chosen for the BMV.

2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.